Advertisement
Cautions When Reinstalling the US Mechanism.
This VCR has mechanism sensors on the MAS board
and the capstan and loading motors are connected via
direct connectors.
Therefore, when reinstalling the US
mechanism, observe the following cautions.
1) Align the V mark and mode no. 1 of the mechanism
state switch on the MAS board. (Mode no. 1 of the
mechanism state switch has a click position.)
2) Check that mode no. 1 on the P drive gear in the
mechanism and the'V mark of the spring hook are
aligned. If they are not aligned, turn the loading motor
pulley to align them.
3) Pass the end LED through the hole in the mechanism
and install the mechanism from immediately above
using the installation position holes as reference.
Check
that the boss of the mechanism state switch and the
hole in the cam gear are aligned.
4) Push the terminal sections (shaded sectionsZ7J] )
of the capstan and loading motors and check that they
are inserted securely.
INSTALLATION
=O
POSITION HOLE
BOSS
MECHANISM
STATE SWITCH
HOLE IN
CAME GEAR
INSTALLATION
POSITION HOLE
ALIGH
No.1
AND THE ARROW
MECHANISM
STATE
SWITCH
Fig. 2-8
INSTALLATION
POSITION HOLE
SPRING HOOK
@.
foeN
CHECK THE
ALIGNMENT
MARKS.
P.DRIVE GEAR
HOLE FOR END LED
LOADING
MOTOR
PULLEY
Fig. 2-9
PRESS
INSTALLATION
POSITION
HOLE
Advertisement
Chapters
