Hitachi VT-FX8000E Service Manual page 109

2, Checking the operation in each mode
i Mode
Operation in each mode | switch
i position
LOADING-STOP 1 mode i 6
Recording/piayback modes
Press the record or playback button }
of the VCR, The take-up reel disk {
starts to turn. H
Press the stop button of the VCR.
The take-up reek disk stops.
T |
i
Enon |S
* To set to the record mode, pull the safety arm
forward,
Still play mode
Press the playback button of the VC
The take-up reel disk starts to tur
Press the pause button,
Take-up reel disk and capstan stop.
Press the stop button,
The take-up reel disk and capstan 6
turn forward and then stop,
Record pause mode
Press the record button of the VCR. |
The tension arm is released and the | 3
supply ree] disk turns in reverse. i
—_
The tension arm is pressed and the
take-up reel disk and capstan shaft
to turn forward,
_——--——
6
T i
t i
i i
L
UE hime ees
Press the pause button, The tension
am is released and the supply reel
disk turns in reverse, then the take~
T |
i ;
up reel disk and capstan shaft turn |
} |
| \
H H
forward. When the start of 2
programne is located, the VCR enters
the pause mode.
Press the rewind button. The tension
am is released and the T-brake is
applied,
The reel disk starts to turn. \ 3
Press the stop button.
The T-brake is released and the
tension arm is pressed.
H 1
1 i
i i
i
a
After completing the check, be sure to reset the VCR to the original state by the following procedure.
1) Turn the VCR off.
2) Remove the masking tape, etc. from the supply and take-up end sensors.
3) Unplug the mains lead from the AC outlet to reset the microprocessor(s).
4) Install the cassette loading mechanism to complete the work.