Getting Connected - VocoPro UDX Series Owner's Manual

Getting Connected

1. Start by attaching the antenna to the receiver. The antenna will connect to the sockets on the back of the
receiver labelled ANT-A and ANT-B. Screw the antenna on by twisting clockwise until they are tight.
2. Get the power adapter, connect the small end to the DC INPUT on the back of the receiver and plug the other end
into a wall socket or power strip.
ANT-1 CH-1
3. Connect the receiver to your mixer, amplifier, or powered speaker by using the audio outputs on the back of the
receiver. There are 3 different options available on the UDX-OCTO receiver. Using option 1 or 2, you will have to
use the volume controls on the UDX-OCTO receiver to control the volume for your mics. Using option 3 will allow
you to set the initial volume output on the receiver, and then control the volume from your mixer after setup.
ANT-1 CH-1
¼
Option 1: Using the
If the device you are connecting to only has
inch mixed out. Using the included
ANT-1 CH-1
and connect the other end to the mic input on your device.
ANT-1 CH-1
ANT-1 CH-1
18 \
ANT-1 CH-1
CH-2 CH-3 CH-4 CH-5
CH-2 CH-3 CH-4 CH-5
inch Mixed Out
¼
¼
inch audio cable, connect one end to the
CH-2 CH-3 CH-4 CH-5
CH-2 CH-3 CH-4 CH-5
CH-2 CH-3 CH-4 CH-5
CH-2 CH-3 CH-4 CH-5
CH-6 CH-7 CH-8
CH-6 CH-7 CH-8
inch mic inputs, the easiest way to connect will be using the
CH-6 CH-7 CH-8
CH-6 CH-7 CH-8
CH-6 CH-7 CH-8
CH-6 CH-7 CH-8
DC INPUT
MIC OUT
MIX OUT
DC INPUT
MIC OUT
MIX OUT
DC INPUT
¼
inch MIX OUT on the receiver
MIC OUT
MIX OUT
DC INPUT
DC INPUT
MIC OUT
MIX OUT
MIC OUT
MIX OUT
DC INPUT
MIC OUT
MIX OUT
DC INPUT
ANT-2
ANT-2
¼
ANT-2
ANT-2
ANT-2
ANT-2