Syncing The Transmitters To The Receiver - VocoPro UDX Series Owner's Manual

Syncing the Transmitters to the Receiver

Once we have the receiver hooked up, we can begin syncing the transmitters to the different channels on the
receiver.
First, make sure all your transmitters have fresh, good quality batteries installed, and they are all powered on.
Check the battery indicator on each transmitter.
Power on the receiver and wait a couple seconds for the system to start up.
Choose the channel you want to pair to, and hold down the IR Button on that channel until the IR light on the
receiver begins flashing, about 3 seconds.
Hold the IR sensor on the transmitter up to the IR light on the receiver. For the UDX-HT handheld mic and the
UDX-CF conference mic, the IR sensor is built into the display screen so you simply need to point the screen
at the IR light. For the UDX-BP body pack, the IR sensor is under the battery cover so you will need to open the
battery cover and point the front towards the IR light.
UDX-HT
UDX-CF
20 \
UDX-BP
UDX-GT9
UDX-GT3
UDX-IT
IR
CH 255
927.60
MHz
MUTE
CH
IR 909-928 MHZ