YOODA DVH55B Manual

www.sukcesgroup.pl
Non-compliance with the specification might cause risk for life or health and can determine proper work of the blind.
We strongly recommend to comply with the specification.
Installation of the tubular motor should be performed by specialists with 1kV or higher SEP-certified electrician's licence (SEP - Association of Polish
Electrical Engineers) or equal license.
Motor for facade blind DVH55B
Motor for facade blind DVH55B
power plug
2. Safety
Before installing or using motor please read the following instruction. The installer must comply with the standards and regula-
tions in force in the country where the appliance will be installed and provide information to users about the conditions and
maintenance of the device. Failure to follow these instructions can present risk to life and health, or invalid functioning of the
roller shutter. This also results in the loss of warranty rights.
1. Motors torque parameter should be adequate to the weight of the roller shutter curtain.
2. Motor cables must be secured so that they are not damaged by a working blind.
3. Electrical system control should be performed regularly to detect any signs of use or damage of the motor.
4. Electrical supply needs to be disconnected before conducting any maintenance, cleaning and/or repair work.
5. All contact of the motor with any liquids should be reduced to minimum.
6. Motor and its control system should be kept out of children reach.
MOTORS FOR FACADE BLIND DVH55B
power socket
1
The DVH55B series motors are designed to automate the work
of facade blinds.
They have electronic limit switches that stop the motor when
the blind is open or closed. The motor has an emergency stop
button that protects the blind against damage.
Power supply:
230 V / 50 Hz
Speed:
26 RPM
Max. number of rotations:
∞
Max. time of work:
6 min.
Operating temperature:
from -10°C to 50°C
Protection degree:
IP54
emergency
stop button