Table of Contents
Advertisement
"TUNER
Press the POWER switch to the ON position.
Select TUNER with the INPUT SELECTOR.
Be sure to turn the TAPE 2 MONITOR button OFF when listening to
AM or FM broadcasts.
,
STATION CALL
JOG
°
2
e
AUTO
BAND
TUNING
(=: 4}
DIRECT ACCESS
MANUAL TUNING
1, Use the BAND button to select either FM or AM.
2. Select your desired frequency with the JOG dial.
* Turn the JOG dial clockwise and the frequency increases; turn
it counterclockwise and the frequency decreases.
© When a station is received, the TUNED indicator lights.
AUTO TUNING
FM auto stereo reception and monaural reception
Each time you press the MPX MODE button, the FM MONO indicator
in the display section lights or goes out.
* If an FM stereo broadcast is received when the FM MONO
indicator is out, the STEREO indicator lights, and sound is in stereo.
° if an FM stereo broadcast is received when the FM MONO
indicator is lit, the sound will be monaural.
if there is interference during STEREO mode reception, switch to
FM MONO. The sound will become monaural but interference will
be reduced.
Direct access tuning example: To receive FM 106.00 MHz
oumcr
Accane
i
4
| a
1. Use the BAND button to select either FM or AM.
2. Press the ''+"' or ''-"" button of the AUTO TUNING buttons.
© Pressing "' +' causes scanning to take place in the direction of
increasing frequency. Pressing "'~'' causes scanning to take place
in the direction of decreasing frequency.
* When a station is received,
scanning
will stop {the TUNED
indicator lights}. If you wish to receive a different station, press
the AUTO TUNING button (°+" or "'~"") again.
DIRECT ACCESS TUNING
When you know the frequency of the desired station, the frequency
can be input directly using the STATION CALL (number} buttons in the
following way:
1. Use the BAND button to choose either FM or AM.
2. Press the DIRECT ACCESS button.
3. Input the desired station frequency using the STATION
CALL
buttons.
2
To cancel frequency input
if none of the STATION CALL buttons {} #1]
—|*0}
are pressed for
approximately five seconds, the unit returns to the state it was in before
the DIRECT ACCESS button was pressed.
26
<ARB1420>
4
4
FOR MULTIVOLTAGE
MODEL
* When the CHANNEL STEP switch is set to FM 100 kHz step, the
tuning operation is completed and reception begins.
17600 ~
——-J
When the CHANNEL STEP switch is set to FM 50 kHz step:
Tb O-
u
10600 -
|
+0
7
a
Advertisement
Table of Contents
