Port Triggering - D-Link Go-RT-N300 User Manual
N300 wi-fi router
Hide thumbs
Also See for Go-RT-N300:
- User manual (83 pages) ,
- Quick installation manual (33 pages) ,
- Quick install manual (13 pages)
Table of Contents
Advertisement
Section 3 - Configuration
This page allows you to enable port triggering to specify inbound traffic to be sent to specific ports while other ports are in use for outbound traffic. The
Go-RT-N300 provides some predefined applications in the table on the bottom of the web page. Select the application you want to use and enable it.
NAT Port Trigger:
Enable or disable the Nat Port Trigger service.
Usual Application
Select an application from the drop-down list.
Name:
User-defined
Enter the name of an application/rule.
Application Name:
Start Match Port:
Enter a start match port.
End Match Port:
Enter a end match port.
Trigger Protocol:
Select a protocol from the drop-down menu.
Start Relate Port:
Enter a start relate port.
End Relate Port:
Enter an end relate port.
Open Protocol:
Select a protocol from the drop-down menu.
Nat Type:
Select whether it will be outgoing or incoming.
Apply Changes:
Click to save your rule.
D-Link GO-RT-N300 User Manual
Port Triggering
30
Advertisement
Table of Contents
