This page allows you to enable port triggering to specify inbound traffic to be sent to specific ports while other ports are in use for outbound traffic.
NAT Port Trigger:
Enable or disable the Nat Port Trigger.
Click the Apply button to save any changes made.
Usual Application
Select an application from the pulldown list.
Name:
User-defined
Enter the name of an application.
Application
Name:
Start Match Port:
Enter a start match port.
End Match Port:
Enter a end match port.
Trigger Protocol:
Select a protocol from the pulldown menu.
Start Relate Port:
Enter a start relate port.
Enter an end relate port.
End Relate Port:
Select a protocol from the pulldown menu.
Open Protocol:
Click the Apply Changes button to save any changes made.
The application will then be added to the Current Portrigger Table. Click the Delete button in the Action field for an application type if you wish