Wps Setup - D-Link Go-RT-N300 User Manual

Section 3 - Configuration
Wi-Fi Protected Setup (WPS) System is a simplified method for securing your wireless network during initial setup as well as the "Add New Device" processes.
The Wi-Fi Alliance (WFA) has certified it across different products as well as manufactures. The process is just as easy as pressing a button for the Push-Button
Method, or correctly entering the 8-digit code for the Pin Code Method. The time reduction in setup and ease of use are quite beneficial, while the highest
wireless security setting of WPA2 is automatically used.
PIN of the router: Displays the current PIN for the router's WPS connection. Wireless
clients connecting to the router using the PIN method should enter
this PIN in order to connect.
Enable WPS: Check the box to enable devices to connect to the router using
WPS.
Disable PIN:
Check the box to disable the PIN connection method. If this option
is disabled, clients can only use the PBC method to connect.
Keep current Check this box to lock the current configuration. If this option is
configuration: disabled, wireless clients will not be able to automatically adjust
the router's WPS settings when connecting.
Access Control
Click this button to be taken to the Access Control setup tab, where
List: you can configure filters to control which wireless clients access
your network, and which network resources they can access.
Enable Wireless Click to enable Wireless Access Control Mode. In this mode, only
Access Control
listed wireless devices will be allowed to connect to the wireless
Mode: network. Click the Apply button when you are done.
MAC Address: Enter the MAC Address of a device you wish to allow access for
to the WLAN. Click the Add button when you are done. This will
add the device's MAC Address to the table above.
Select a device in the list and click the Delete button to delete
the device.
D-Link GO-RT-N300 User Manual

WPS Setup

26