Pioneer VSX-D712 Operating Instructions Manual page 44

D _ Setting up the receiver
Chapter 6:
Setting up the receiver
D
Choosing your receiver setup
To ensure the best possible surround sound,
be sure to complete the following set up
operations. This s particularly important
when using DTS and Dolby surround, You
only need to make these sett ngs once (unless
you change the placement of your current
speaker system or add new speakers, etc.),
Refer to the following pages for details on
each of the settings,
A Imporlmnt
• If you are using the Pioneer S-FCRW230/
730 speaker system, make sure the
Subwoofersetting is set to YES and the
Speakersetting is set to FS-CS-SSYou'll
also have to change the Crossover
frequency setting to 200Hz,
O iiiiiiiiiiiiiii
[} } i}
C E} i}
([[ ( ><[ ([)
() > < ? (?
(z) c> ( ) L_
1 Press RECEIVER© to turn the power
on.
The STANDBY indicator goes out,
2 Press RECEIVER.
3 Use ¢_ or => to choose the option you
want to adjust.
It will be easiest to adjust each of the sett ngs
n turn, following the order below (and on the
following pages), The culrent setting s shown
for each option as you cycle through the
d splay,
Speaker setting (page 45)
Spec fy the number and type of speakers
you have connected,
Surround back speakersetting
(page 46)
Specify yoursurround back speake_
surround back subwoofersetup,
Subwoofer setting (page 46)
Spec fy how the subwoofer is used.
Crossover frequency setting (page 46)
Determine which frequencies will be sent
to the subwoofer (or large speakers),
LFE attenuator setting (page 47)
Choose the attenuator level for the LFE
channel.
Front left speaker distance setting
(page 47)
Spec fy the distance from your listening
position to your front left speaker.
Center speaker distance setting
(page 47)
Spec fy the distance from your listening
position to your center speaker.
Front right speaker distance setting
(page 48)
Spec fy the distance from your listening
position to your front rght speaker,