Pioneer VSX-D712 Operating Instructions Manual page 27

Connecting up
• If you're not using a subwoofer, change
the front speaker setting (see Speaknr
setting on page 45) to large.
• VeX-D712 only., if you connect to a
surround back speaker, make sure the
Surround bact_speakersetting on page 46
s switched on and set to the proper
speaker size.
AC outlet
Power supplied through this outlet is turned
on and off by the rece veCspower swtch.
Total electrical power consumption of
connected equipment should not exceed 100
w (0.8A).
_'_ No'l_e
• Make sure no exposed speaker wire is
touching the rear panel, this may cause
the receiver to turn off automatically,
• This unit should be disconnected by
_emoving the power plug from the wall
socket when not in _egular use (ex. when
on vacation).
Power cord caution
Handle the power cord by the plug. Do not
pull out the plug by tugging the cord and
never touch the power cord when your hands
a_e wet as this could cause a short circuit or
an electric shock. Do not place the unit, a
piece of furniture, etc. on the power cord, or
pinch the cord. Never make a knot in the cord
or tie it with other cords. The power cords
should be _outed such that they are not likely
to be stepped on. A damaged power cord can
cause a fire or give you an electrical shock,
Check the power cord once in a while. When
you find it damaged, askyour nearest Pioneer
authorized service center or your dealer for a
replacement.
C_ution
• Do not connect a monitor, TV set, heater,
or similar appliance to this unit's AC
outlet.
• Do not connect appliances wth high
power consumpt on to the AC outlet n
order to avoid overheating and fire rsk.
This can also cause the receiver to
malfunction,
ER