Pioneer VSX-D712 Operating Instructions Manual page 66

D _ Additional information
D
Broadcast stations can not be • Connect an outdoor antenna (refer to page 20).
selected automatically,
No sound from surround or • Refer to Speaker setting on page 45 to check the speaker settings.
center speakers, • Refer to Manual/y cafibratlng your listening area (MCACC_ on
page 51 to check the speaker levels,
• Connect the speakers properly (refer to page 21 or page 22),
No sound from surround ,RefertoSurroundbackspeakersettingonpage46tocheckthesur-
back speakers, round back speaker settings,
• Refer to Using the Surround Back Channel (SB CH) on page 40 to
make sure the SB CH MODE and the sound mode are set for sur-
round back sound,
No sound from subwoofer • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make su_ it's turned up.
• Switch the Subweofersett_ng on page 46 to YES or PLUS.
• Switch the LFE attenuator setting on page 47 to OdB or 10 dB.
• The Dolby Digital or DTS source you are listening to does not have
an LFE channel,
Noise during playback of a • Move the cassette deck further from your receiver, until the noise
cassette deck, disappears,
Sound is produced from • Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG accord-
other components, but not ing to the type of connections made, (refer to page 37),
from LD or DVD playen • Set the digital input settings correctly (refer to page 50).
• Make digital connections (refer to page 16) and set the SIGNAL
SELECTto DIGITAL (refer to page 37),
• Refer to the instruction manual supplied with the DVD player
NO sound is output or a noise • Set the digital volume level of the player to full, or to the neutral
is output when software with position.
DTS is played back.
When a search is performed • This is not a malfunction, but be sure to turn the volume down to
by a DTS compatible CD prevent the output of loud noise from your speakers,
player during playback, noise
is output.
Can't operate the remote • Replace the batteries (refer to page 6),
control. • Operate within 23 feet ( 7 m), 30° of the remote sensor on the front
panel 0_fer to page 7),
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light,
The display is dark or off, • Press FL DIMMER on the remote control repeatedly to return to
the defaulb