Setting
up the receiver
3
Press MASTER VOLUME
+/-to
adjust
the volume
to an appropriate
level.
4
Use LEVEL +/- to adjust the speaker
levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main I sten ng position. The channel
level
range s _+ 10 dB.
S
When you're done, press TESTTONE to
turn off the test tone.
The receiver returns to the Standard
mode,
Tip
• The speaker volume can be adjusted
without
outputting
the test tone by
press ng CH SELECT and then usng
LEVEL +/-+ However, you can only adjust
the level of the speakers currently
active
n the mode you're I stening
to. You can
set separate
levels for the STANDARD,
STEREO and DVD 5.1 ch/DVD 7.1 ch
modes+ as well as for each ADVANCED
SURROUND
mode.
]Note
• Since the subwoofer
transmits
an ultra-
low frequency
its sou nd may seem q uieter
than it actually is.
• Usng
test tones to set up your speaker
system will overwrite
any previous
settings you had for the STANDARD
or
ADVANCED
SURROUND
modes.
ER