Frequently asked questions
Message
Clean the lint filter.
Check the air-
ways.
continues
to light up after a
program has
been canceled,
despite thorough
cleaning.
Empty the container
or check the drain.
lights up after a
program has
been canceled.
Blockage detected.
Untangle laundry
and restart
up after a pro-
gram has been
canceled.
60
Possible cause and solution
The plinth filter looks clean after thorough cleaning.
However, the program terminates and the fault mes-
sage appears again. It is likely that there is still un-
derlying residue that could not be removed.
To switch off the message: press
Check for the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
described in "Frequently Asked Questions –
Checking the heat exchanger".
The plinth filter is clogged further down.
Check the plinth filter. Follow the instructions de-
scribed in "Frequently Asked Questions – Replac-
ing the plinth filter".
If the plinth filter is not deformed or defective, you
can reactivate it in the washing machine. Follow
the instructions described in "Frequently Asked
Questions – Reactivating the plinth filter".
The condensed-water container is full or there is a
kink in the drain hose.
Empty out the condensed-water container.
Check the drain hose.
To switch the fault message off:
Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. Remove a
lights
few items, if necessary.
Switch the dryer off and then on again.
Start a program.
OK
.