Table of Contents
Advertisement
●
If a higher level is specified, the printing speed will be slower.
<Auto Clean Fixing Assembly>
If the fixing assembly is dirty, edges or the back side of the paper may get smudged. You can configure to
perform automatic cleaning of the fixing assembly to prevent smudges. When <On> is specified, a sheet of
paper is output each time cleaning is performed. Configure so that paper feed is performed from the paper
source in which paper usable for cleaning is loaded.
<Off>
<On>
<Multi-Purpose Tray>
<Off>
<On>
<Drawer 1>
<Off>
<On>
*
<Drawer 2>
<Off>
<On>
<Menu>
<Adjustment/Maintenance>
Clean Fixing Assembly>
●
You can use the following paper for cleaning.
- Paper sizes: A4/Letter
- Paper types: Plain 1 to 3/Recycled 1 or 2
<Rdc. Condens. (1-Sd->2-Sd Prt)>
When performing 2-sided printing after 1-sided printing, the printed images may be faint due to moisture
condensation. In this case, setting to <On> may solve the problem.
<Off>
<On>
<Menu>
<Adjustment/Maintenance>
Condens. (1-Sd->2-Sd Prt)>
Setting Menu List
*
<Adjust Image Quality>
<On>
<Yes>
Set available paper sources to <On>
*
<Adjust Image Quality>
<On>
<Yes>
495
<Special Processing>
<Auto
<Apply>
<Special Processing>
<Rdc.
Advertisement
Table of Contents
