Table of Contents
Advertisement
Procedure for Setting to Send E-Mail/Send and Receive
I-Fax
Before configuring the machine for scanning to e-mail, check the setup flow shown below.
Setting Up
Make sure that the machine and the computer are correctly connected.
Connecting to a Wireless LAN(P. 19)
Connecting to a Wired LAN(P. 18)
Make sure that you have the following information:
●
The IP address of the machine.
●
An e-mail address to be registered as a destination.
●
Information about the e-mail server, including the SMTP server name, port
numbers, whether authentication is required, and the user name and password
for authentication.
●
For more information about the e-mail server settings, contact your Internet
service provider or Network Administrator.
Make sure that the computer meets the system requirements for the Send
Function Setting Tool (sending e-mail).
●
System requirements for the Send Function Setting Tool
Environment(P. 676)
●
Also make sure that <Use HTTP> and <Use Remote UI> are set to <On>.
Disabling HTTP Communication(P. 422)
Disabling Remote UI(P. 423)
Set the machine configuration.
●
Configuring Basic E-Mail Settings
●
Configuring I-Fax Receiving Settings
Communication Settings(P. 90)
●
Configuring Detailed E-Mail/I-Fax Communication Settings (Authentication,
Encryption, etc.)
Configuring E-Mail/I-Fax Communication Settings(P. 90)
86
Viewing Network Settings(P. 39)
Configuring Basic E-Mail Settings(P. 87)
Configuring E-Mail/I-Fax
3S21-01L
System
Advertisement
Table of Contents
