Kenwood TM-241A Instruction Manual page 32

and the third digit begins to flash.
7. Select the third digit by rotating the Tuning control.
8. Press the DR/DT key and the complete DTSS code is
registered. The mode returns to the previous one.
@ Selecting and storing a code with the DTMF
KEY PAD (MC-44DM)
1. Press the DR/DT key to light the DTSS indicator.
2. Press the F key, then press the DR/DT key while the F
indicator is on (10 seconds). The DTSS code setting
mode will be entered and the first digit of the code
will flash.
3. Then enter a three-digit number on the key pad.
aa
of
DOOSIO © Geeelo:
OOO O p
Notes
1, lf a key other than the DR/DT key on the front
pannel is pressed during operation, code selection
mode is canceled.
2. If no action is taken for longer than 10 seconds,
code selection mode is automatically canceled.
32
5-8-3 Selection using memory channels 1
through 3
@ Storing VFO frequencies and DTSS codes at
the same time
1. Select the desired frequency to be stored in memory
in the VFO mode.
. Follow steps 1 through 8 above in the VFO mode.
. Press the F key
. Select the desired memory channel (1, 2, or 3) with
the tuning control or the UP/DWN key on the micro-
phone.
PWN
5. Press the MR/M key
@ Rewriting DTSS codes in memory channels
(1 to 3)
1. Press the F key while the memory channel is operat-
ing, then press the DR/DT key while the F indicator is
on. The DTSS code setting mode will be entered and
the first digit of the code will flash.
2. Store the selected code in memory.
Follow steps 1 through 8 in VFO mode to edit a
stored code.