Kenwood TM-241A Instruction Manual page 26

5-5-3. Band Scan
1, Press the VFO/MP
V key to select the VFO mode.
2. Adjust the SQL control to the threshold point.
4. Flashing
26
5-5-4 Programmable Band Scan
Notes
3. Press the VFO/ MP V key to select the VFO mode.
4.Select a VFO
frequency between
the two
5.
programmed scan limits.
6. Scan will begin in an upward direction.You can
reverse the direction by rotating the Tuning control
counterclockwise, or by pressing the microphone
DWN switch.
7. Scan will stop whenever a signal is received (that
activates the BUSY indicator) for a limited time.
8. Press the PTT switch or any front panel key to stop
scanning.