Table of Contents
Advertisement
NLTroubleshooting
Malfunction
Program does not start.
The program duration
changes during
drying.
Pump sound.
Buzzing sound.
Drying time is too long.
Water is leaking.
Laundry is too damp.
46
Cause and Troubleshooting
Child lock is activated.
→
"Deactivate childproof lock", page 33
▶
was not pressed.
Press .
▶
No program set.
→ "Set program", page 29 .
1.
→ "Starting the program", page 30 .
2.
The program sequence is optimized electronically. This
may lead to changes in the program duration.
No error - no action required.
▶
Condensation water pump active.
No error - normal operating noise.
▶
Compressor vent active.
No error - normal operating noise.
▶
Fluff filter is dirty.
→ "Clean the fluff filter", Page 31
▶
Ambient temperature is higher than 30°C.
Make sure the ambient temperature is below 30°C.
▶
Ambient temperature is lower than 15°C.
Make sure that the ambient temperature is above
▶
15 °C.
Insufficient air circulation at the installation site of
the device.
Ventilate the installation site of the device.
▶
Ventilation opening of the device is blocked.
Make sure that the ventilation opening of the device
▶
is kept clear.
Heat exchanger is contaminated.
Perform simple device maintenance on the device.
▶
→ "Device care", page 39
The appliance is not leveled properly.
→ "Adjusting the device", page 14
▶
Unsuitable program for the type of fabric set.
Set a time program for post-drying.
▶
→ "Programs", page 25
Power supply has failed.
Advertisement
Table of Contents
