Operation - Worx WG927E Original Instructions Manual

the blades, blade bolts
and cutter assembly are
not worn or damaged.
Replace worn or damaged
blades and bolts in sets to
preserve balance;
d) On multi-bladed machines,
take care as rotating one
blade can cause other
blades to rotate.

OPERATION

a) mow only in daylight or in
good artificial light;
b) avoid operating the
equipment in wet grass,
where feasible;
c) always be sure of your
footing on slopes;
d) walk, never run;
e) for wheeled rotary
machines, mow across the
face of slopes, never up and
down;
f) exercise extreme caution
when changing direction on
slopes;
g) do not mow excessively
steep slopes;
h) use extreme caution when
reversing or pulling the
lawnmower towards you;
i) stop the blade(s) if the
lawnmower has to be
tilted for transportation
when crossing surfaces
other than grass, and
when transporting the
lawnmower to and from the
Cordless Lawn Mower
area to be mowed;
j) never operate the
lawnmower with defective
guards, or without safety
devices, for example
deflectors and/or grass
catchers, in place;
k) switch on the motor
carefully according to
instructions and with
feet well away from the
blade(s);
l) do not tilt the lawnmower
when switching on the
motor, except if the
lawnmower has to be tilted
for starting In this case,
do not tilt it more than
absolutely necessary and
lift only the part which is
away from the operator;
m) do not put hands or feet
near or under rotating
parts. Keep clear of the
discharge opening at all
times;
n) not to touch the blades
before the disabling device
has been removed and
the blades have come to a
complete stop;
o) Do not start the lawnmower
when standing in front of
the discharge opening.
p) Do not transport the
lawnmower while the
power source is running.
q) Stop the lawnmower,
and remove the disabling
13
EN