TABLE OF CONTENT conditions. Water entering a power tool will increase the risk of electric shock. 1. PRODUCT SAFETY d) Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. 2. COMPONENT LIST Keep cord away from heat, oil, sharp edges 3.
Page 4
b) Do not use the power tool if the switch does not explosion or risk of injury. turn it on and off. Any power tool that cannot be f) Do not expose a battery pack or tool to fire controlled with the switch is dangerous and must or excessive temperature.
Page 5
Recharge only with the charger specified personal injury. by Worx. Do not use any charger other than l) When working on slopes, always be sure of your that specifically provided for use with the footing, always work across the face of slopes, equipment.
Page 6
Li-Ion battery This product has been marked with a symbol relating to ‘separate collection’ for all battery packs and battery pack. It will then be recycled or dismantled in order to reduce the impact on the environment. Battery packs can be hazardous for the environment and for human health since they contain hazardous substances.
2.COMPONENT LIST Machine Weight (bare 10.4 kg tool) SAFETY KEY ** X=1-999, A-Z, M1-M9 there are only used for different customers, there are no safe relevant changes between SWITCH LEVER these models. CABLE CLIP ***Voltage measured without workload. Initial battery voltage reaches maximum of 20 volts.
drilled. Checking the battery charge The tool being in good condition and well maintained condition Using the correct accessory for the tool and ensuring it is NOTE: Fig. D1 only applies for the See Fig. D1 sharp and in good condition. battery pack with battery indicator The tightness of the grip on the handles and if any anti light.
Page 15
2. Release bail handle to turn mower “OFF” when Removing/emptying grass collection crossing any graveled area (stones can be thrown by the blade). WARNING! Always check the 3. Set mower at highest cutting height when mowing in safety flap close the discharge rough ground or in tall weeds.
6.MAINTENANCE using a spanner wrench, and then remove blade. To re-assemble, position the blade (18) with the cutting edges towards the ground. Then securely tighten the blade WARNING: Stop the mower and remove the bolt (17). safety key before removing the grass bag. NOTE: To ensure long and reliable service, perform the FOR BATTERY TOOLS following maintenance procedures regularly.
9.TROUBLESHOOTING Problem Solution 1. Mower doesn’t run when bail A. Check to make sure safety key has been installed and is fully seated and that handle is activated. button on switch housing is being completely pushed. B. Release bail handle to turn mower off. Remove safety key, turn mower over and check that blade is free to turn.
Need help?
Do you have a question about the WG779E Series and is the answer not in the manual?
Questions and answers