Removing The M.2 2280 Solid-State Drive - Dell OptiPlex 5090 Small Form Factor Service Manual

Steps
1. Align the solid-state drive with the socket on the system board and slide it in.
2. Replace the single (M2X3) screw that secures the M.2 solid-state drive to the system board.
Next steps
1. Install the 2.5/3.5-inch hard-drive
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in

Removing the M.2 2280 solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5/3.5-inch hard-drive
About this task
The following images indicate the location of the M.2 2280 solid-state drive and provide a visual representation of the removal
procedure.
caddy.
after working inside your
before working inside your
caddy.
computer.
computer.
Removing and installing components 25