Table of Contents
Advertisement
About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the installation
procedure.
Steps
1. Slide the intrusion switch into the slot on the chassis.
2. Insert the connector from intrusion switch cable into the connector on the system board until it clicks into place.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Front bezel
Removing the front bezel
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
About this task
The following images indicate the location of the front bezel and provide a visual representation of the removal procedure.
16
Removing and installing components
after working inside your
before working inside your
computer.
computer.
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex 5090 Small Form Factor and is the answer not in the manual?
Questions and answers