5. Identify the Right Footrest Bottom (31) and orient
it as shown.
See the inset drawing. Slide the Right Footrest
Bottom (31) under the Right Footrest Bracket
(27) so that the Right Footrest Bottom slides into
the indicated cutout (E).
Attach the Right Footrest Bottom (31) to the
Right Footrest Bracket (27) with four M4 x 16mm
Machine Screws (104); start all four Machine
Screws, and then tighten them.
Attach the Left Footrest Bottom (32) in the
same way.
6. See the inset drawing. Locate the indicated
pin (B) on the Rear Leg (5). Insert the pin into
the keyhole (C) in the rower Frame (1), and then
slide the Rear Leg downward until it stops. Make
sure that the pin is holding the Rear Leg in
place.
Then, attach the Rear Leg (5) with three
M10 x 55mm Screws (114); start all three
Screws, and then tighten them.
5
32
31
104
6
114
5
9
27
104
27
E
5
1
B
C
31