Page 1
General-Purpose Pressure Sensor E8EB Ideal for Workpiece Presence Detection Models with a pressure sensing range of 0 to 14.21 psi are ideal for workpiece position checking Models with a pressure sensing range of 0 to 142 psi are ideal for original...
IEC60529 IP54 Pressure port (PT) 1/8 J CHARACTERISTICS Item/Model E8EB-10C, E8EB-10B E8EB-01C, E8EB-01B, E8EB-N0C2B, E8EB-N0B2B Temperature influence 0.12% FS/ C between 0 C and 50 C 0.2% FS/ C between 0 C and 50 C (32 F and 122 F) (32 F and 122 F) 0.2% FS/ C max.
E8EB E8EB Engineering Data J TEMPERATURE VS OPERATING J PRESSURE VS. DIFFERENTIAL TRAVEL PRESSURE (TYPICAL) (TYPICAL) E8EB-01C E8EB-01C 14.2 Temperature ( C) Pressure (psi) J PRESSURE VS. LINEAR OUTPUT J VOLTAGE VS. OPERATING VOLTAGE (TYPICAL) PRESSURE (TYPICAL) E8EB-01C 14.2 –14.2 142.1...
Page 4
E8EB E8EB J LINEAR OUTPUT FLUCTUATION VS. J LINEARITY (TYPICAL) TEMPERATURE CHARACTERISTICS (TYPICAL) E8EB-01C E8EB-01C 14.2 Temperature ( C) Pressure (psi) J VOLTAGE VS. LINEAR OUTPUT FLUCTUATION (TYPICAL) E8EB-01C Voltage (V)
Not lit J GAP MEASUREMENT When checking the gap between the workpiece and the nozzle, as shown in the illustration, the output of the E8EB varies with the surface roughness of the workpiece or the dimensions of the nozzle. Workpiece...
Page 6
E8EB E8EB Examples with E8EB-01C (Typical) Influence of Surface Roughness of Workpieces Influence of Nozzle Diameter Conditions Conditions Nozzle dia.: 2 mm Nozzle length: 10 mm Nozzle length: 10 mm Surface roughness of work- Air pressure: 98 kPa (1 kgf/cm piece: 1.6-Sooo...
Page 7
Make sure that the tightening torque of the M5 female screw is Pressure Setting 9.8 N S m or 100 kgf S cm (7.22 ft S lbf) A rubber bushing is provided with the E8EB. After the pressure is Diaphragm set with the pressure adjuster, cover the adjuster with the rubber...