Advertisement
E8EB
Dimensions
Unit: mm (inch)
J E8EB
Precautions
J MOUNTING
The pressure port has an Rc (PT) 1/8 taper screw. Apply sealing
tape around the female taper screw so that no pressure leakage
will occur.
The most-suitable wrench is 17 mm in size.
Make sure that the tightening torque of the M5 female screw is
9.8 N S m or 100 kgf S cm (7.22 ft S lbf)
Diaphragm
If the diaphragm is damaged, the Pressure Sensor will not
operate properly. Do not insert a screwdriver or steel wire into the
interior of the pressure-sensitive parts through the pressure port.
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.
OMRON ELECTRONICS, INC.
One East Commerce Drive
Schaumburg, IL 60173
1-800-55-OMRON
Cat. No. CEDSAX3
33.2
(1.31)
44
(1.73)
17
(0.67)
30
(1.18)
Vinyl-insulated round cable with four conductors, 3.8 dia. (standard length: 2 m)
R
10/99
Specifications subject to change without notice.
21
(0.83)
8.5
(0.33)
3.5
(0.14)
3.7
(0.15)
7 dia.
(0.28)
0.1
(19
)
.004
(75
)
Pressure
setting
Two,
4.4-dia.
holes
(0.17)
17.5
1.5
10.9
(0.69)
(0.06)
(0.43)
J CORRECT USE
Available Gases
No corrosive or flammable gas can be used.
Filter the gas with an appropriate air filter so that the applied gas
will be free of moisture or oil.
Pressure Setting
A rubber bushing is provided with the E8EB. After the pressure is
set with the pressure adjuster, cover the adjuster with the rubber
bushing so that no dust or any other foreign material will
penetrate into the interior of the E8EB.
E8EB
12.8 dia.
(0.50)
5.2 x 5.2
(0.20) X (0.20)
Operation indicator
16.4
(0.65)
OMRON CANADA, INC.
885 Milner Avenue
Scarborough, Ontario M1B 5V8
416-286-6465
Printed in U.S.A.
Advertisement
