Measuring a Split Time
1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to measure
elapsed time.
Pressing (A) displays the elapsed time
●
from the start of a race up to the point
when you pressed the button (split
time).
D
Start
A
Split
A
Split release
D
Stop
1/100 seconds
Minutes, seconds
Graphic segments appear and
●
disappear on the display to indicate
measurement of elapsed time.
3.
Press (A) to reset the measurement time
to all zeros.
Watch Operation Guide 3536
Timing the First and Second
Place Finishers
1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to measure
elapsed time.
* This displays the time of the first
finisher.
3.
Press (A) to display the time of the second
finisher.
4.
Press (A) to reset the measurement time
to all zeros.
1/100 seconds
Minutes, seconds
D
Start
A
1st Finisher*
D
2nd Finisher*
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
Setting the Time
The countdown start time can be set in 1-
minute units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least one second.
This causes the hours digits to flash.
Hours
3.
Use (B) and (D) to change the timer hours
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (D) to change the timer
minutes setting.
6.
Press (A) to complete the setting
operation.
11