Danfoss VLT HVAC Drive FC 102 Operating Manual page 5

VLT® HVAC Drive FC 102
Operating Guide
5.9.2 Recommended Fuse Ratings for IEC Installation
5.9.3 Recommended Fuse Ratings for UL Installation
5.10 Enabling Motor Operation
5.11 Selecting the Voltage/Current Input Signal
5.12 Setting Up RS485 Serial Communication
5.13 Configuring the Passive Harmonic Filter (PHF)
5.14 Configuring the dU/dt Filter
5.15 Configuring the Sine-wave Filter
5.16 MCCB Configuration
5.17 Safe Torque Off (STO) Wiring
6 Pre-start Check
7 Commissioning
7.1 Applying Power to the Drive
7.2 Programming the Drive
7.2.1 Parameter Overview
7.2.2 Parameter Navigation
7.2.3 Programming Example for an Open-loop Application
7.2.4 Entering System Information
7.2.5 Configuring Automatic Energy Optimization
7.2.6 Configuring Automatic Motor Adaptation
7.3 Testing Before System Start-up
7.3.1 Testing Motor Rotation
7.3.2 Testing Encoder Rotation
7.4 Starting Up the Drive for the First Time
7.5 Parameter Settings
7.5.1 Parameter Setting Overview
7.5.2 Uploading and Downloading Parameter Settings
7.5.3 Restoring Factory Default Settings Using the Recommended Initialization
7.5.4 Restoring Factory Default Settings Using Manual Initialization
8 Wiring Configuration Examples
8.1 Application Examples
8.1.1 Wiring Configuration for Automatic Motor Adaptation (AMA)
8.1.2 Wiring Configuration for Automatic Motor Adaptation (AMA) without T27
8.1.3 Wiring Configuration: Speed
8.1.4 Wiring Configuration: Feedback
8.1.5 Wiring Configuration: Run/Stop
Danfoss A/S © 2021.11
Contents
AQ262141314214en-000301/130R0880 | 5
104
105
106
106
107
108
108
108
108
109
110
112
112
112
112
113
113
114
115
115
115
115
115
116
116
116
116
117
117
118
118
118
118
119
121
122