Marta MT-IR1212A User Manual page 6

Using accessories or replacement parts that are not recommended or sold by the manufacturer may cause damage to the appliance.
•
Always unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged when not in use.
•
To avoid electric shock and fire, do not immerse in water or other liquids. If this occurs, immediately unplug it and contact service center for inspection.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
•
or instruction concerning use of the appliance by a person responsible for their safety.
Place steam iron on the ironing board carefully.
•
Be careful do not touch metal parts of working surface and water tank during operation.
•
Avoid of ironing zippers, rivets, etc., as they can scratch soleplate.
•
Do not place steam iron on the metal or rough surface.
•
Move steam iron carefully to avoid burns, because of there could be hot water leakage, as well as hot steam.
•
USING THE APPLIANCE
SETTING TEMPERATURE
Sort the fabric: wool with wool, cotton with cotton, etc. Start ironing the fabrics requiring the lowest temperature and progress to the higher ones, because the steam iron heats up quicker than it cools
•
down.
If the fabric consists of various kinds of fibers, start ironing the fabrics requiring the lowest temperature (e.g. article consisting of 60% polyester and 40% cotton should be ironed at the temperature
•
indicated for polyester (•) and without steam.
Turn the temperature control dial round until it is opposite the setting pointer.
•
LABEL
•
••
•••
ANTI-CALC SYSTEM
A special filter inside the water reservoir softens the water and prevents scale build-up in the plate. The filter is permanent and does not need replacing.
NOTE: Use tap water only. Distilled water makes the anti-calc system ineffective by altering its physicochemical characteristics.
Do not use chemical additives, scented substances or decalcifiers.
FILLING THE WATER TANK
Unplug the steam iron before filling.
•
Make sure that both the Steam Control turning Knob and Temperature Control Dial are in "OFF" position.
•
Hold the steam iron in the horizontal position.
•
Slowly pour water into the water fill opening.
•
Do not fill higher than indication "МАX" of the water tank, in order to avoid spilling out of water.
•
If you have to refill while ironing, unplug the appliance from the power supply before filling.
•
EMPTYING THE WATER TANK
The water tank should be emptied after each use.
Unplug the steam iron from the power supply.
•
TYPE OF TEXTILE
Do not iron this article
Synthetics, Nylon, Acrylics, Polyester, Silk
Wool, Rayon
Cotton, Linen
6