Casio 3541 Operation Manual page 31

Auto Time Adjustment by
Bluetooth Connection (Time
Adjustment)
Q1
When does the watch adjust its time?
The watch will connect with the phone and
perform auto time adjustment at around 12:30
a.m., 6:30 a.m., 12:30 p.m. and 6:30 p.m. The
connection is automatically terminated after
auto time adjustment is complete.
Q2
Auto time adjustment is not
performed at a scheduled time.
Is auto time adjustment not being
performed according to its normal
schedule?
Note that auto time adjustment is not
performed for 24 hours after swapping of
the Home Time and World Time, or after
the time setting is adjusted manually on
the watch. Auto time adjustment will
resume 24 hours after either of the above
operations is performed.
Is a timer countdown operation in
progress?
Auto time adjustment will not start at the
scheduled times if a timer countdown
operation is in progress. Stop the timer
countdown operation.
Using the Timer
l
Is auto time adjustment enabled?
Auto time adjustment will not be
performed at the scheduled times unless
it is enabled. Enable auto time
adjustment.
Using the Watch in a Medical Facility or
l
Aircraft
Q3
The watch does not connect with a
phone and adjust its time when I
press (D).
The watch will not adjust its time if you press
(D) while a timer countdown operation is in
progress. Stop the timer countdown operation
and then press (D) again.
Watch Operation Guide 3541
Q4
Time is not displayed correctly.
If your phone is unable to receive a signal
because you are outside its service range or
for some other reason, the watch may not be
able to display the correct time. If this
happens, connect the phone to its network
and then adjust the time setting.
Alarm and Hourly Time
Signal
Q1
An alarm does not sound.
Is the watch's battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
Charging
l
Other than the above.
The alarm's settings may not be
configured. Configure the alarm settings.
Configuring Alarm Settings
l
Q2
The hourly time signal does not
sound.
Is the watch's battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
Charging
l
Other than the above.
The hourly time signal may be disabled.
Enable the hourly time signal.
Enabling the Hourly Time Signal
l
Charging
Q1
The watch does not work even
though it is exposed to light.
The watch stops operating whenever the
battery goes dead. Keep the watch exposed
to light until it recharges sufficiently.
Dead Battery
l
Q2
[R] is flashing on the digital display.
The watch is in the charge recovery mode.
Wait until the recovery process is complete
(about 15 minutes). The watch will recover
more quickly if you place it in a brightly lit
location.
If an alarm, hourly time signal, illumination
●
and/or other power-intensive functions are
used within a short period of time, the
charging capacity of the battery will drop
and cause the watch to go into a charge
recovery mode. Function availability will be
temporarily limited, but functionality will
return after the battery recovers.
Dead Battery
l
Q3
[CHG] is flashing on the display.
The charge level of the watch is extremely low.
Immediately expose the watch to light to
charge it.
Low Battery
l
Other
Q1
I can't find the information I need
here.
Visit the website below.
https://world.casio.com/support/
31