Supermicro SuperServer 620BT-DNTR User Manual page 58

Installing M.2 Carrier-and-Riser Card
1. Power down the node and remove it
2. Remove the expansion card screw (See Figure 3-12) and set aside. Remove the PCI
slot shield.
3. Attach brackets onto the
M.2 carrier-and-riser card, if
necessary.
4. Insert an expansion card
into the riser slot of the M.2
carrier-and-riser card to create
an assembly (not shown).
5. Install the M.2 SSD, if
necessary.
6. Align the assembly with SLOT2 on the motherboard and the PCI slot shield at the node
rear and insert the assembly into the motherboard.
7. Reinstall the expansion card screw, reinsert the node into the chassis, and power up the
system.
Riser Slot
PCI Slot Shield
Figure 3-15. Installing Expansion Card onto M.2 Carrier-and-Riser Card
Chapter 3: Maintenance and Component Installation
from the chassis.
Bracket
Figure 3-14. Installing Brackets
M.2 SSD
58
Bracket