Figure 3-9. Removing Dummy Drive from the Drive Carrier
Installing a Drive
1. Install a new drive into the carrier with the printed circuit board side facing down so that
the mounting holes in the drive align with those in the carrier.
2. Secure the hard drive into the carrier with the screws.
3. Insert the drive and carrier into its bay with the release button on the right. When the
carrier reaches the rear of the bay, the release handle starts to retract.
4. Push the upper part of the drive carrier handle until it clicks into the locked position.
Chapter 3: Maintenance and Component Installation
Figure 3-10. Installing Hard Drive
53