Atag VA6611PTUU/A01 Use & Care Manual page 30

Table of Contents

Advertisement

Troubleshooting
Problems
Water remains in the
machine
Bad odor in the machine
The dishes are not
sufficiently dry
0
Possible causes
• Obstruction in the drain hose.
• Kinks in the drain hose.
• The filters are clogged.
• Items in the drain pump.
• Dirt along the strips and in
corners
• Low­temperature programs
have been selected for a
prolonged period.
• Drying power too low.
The machine is not fully load­
ed.
• The rinse aid has run out or
the set dose is too low.
Action
• Disconnect the drain hose
where it is connected to the
sink's water trap. Check that
no debris has become stuck.
Is the cone­shaped part of the
pipe cut so that the diameter
is at least 16 mm?
• Check that the hose is free
from kinks or sharp bends.
• Clean out the coarse filter, the
fine filter and the filter.
• Clean out the drain pump.
See chapter on cleaning
• Clean with a dish brush and
low­lather detergent.
• Run a Normal Temperature
program around once a
month.
• Activate the Normal drying
option (not all models).
Put a full load in the machine.
• Replenish rinse aid or in­
crease the dose of rinse aid if
required.
• Open the door slightly once
the program has finished.

Advertisement

Table of Contents
loading

Table of Contents