Table of Contents
Advertisement
Height Rider/SP Series
Operating & Safety Instructions
Base Levers
1
1 Operates Platform Levelling
2 Operates the Flyboom
3 Operates Telescoping
4 Operates the Link Booms
5 Operates the Upper Boom
6 Operates Slew
7 Operates Front Wheel Steer
4.2.2
OPERATION
ALL MODELS
1)
Ensure all red emergency stops are out.
2)
Turn key switch at ground control station to Ground (Single turn clockwise).
3)
Push and hold green power button on the base control panel.
4)
Select one or more functions and operate the appropriate hydraulic levers in full accordance with
manufacturer's Operating and Safety Manual. (Refer to Section 4.2.1)
Note: Move lever until resistance is felt, then push/pull harder to activate function.
5)
To enable control to the platform, turn base control key-switch to the Platform position (fully
clockwise).
6)
When not in use return machine to stowed position, turn the base control key-switch anti-
clockwise to the Off position, remove key and chock wheels.
EMERGENCY PROCEDURES
1)
Push in red emergency stop to shut down all functions.
2)
In the event that the controls fail or the operator becomes incapacitated the booms can be
operated by using the manual hand pump which is located under the canopy adjacent to the
base controls. To operate:
a)
b)
c)
24
2
3
Move and hold control lever required.
Operate hand pump handle to move machine.
Release control lever to halt machine movement.
4
Forward for Up
Up for Up
Up for Out
Up for Up
Up for Up
Down for Left
Forward for Right
5
6
Backward for Down
Down for Down
Down for In
Down for Down
Down for Down
Up for Right
Backward for Left
English/USA – 05/15
Original instructions
7
Advertisement
Table of Contents
