Maintenance And Care; General Cleaning - Titan TTL688HDC Safety And Operating Manual

MAINTENANCE AND CARE

WARNING! Always switch the product off, let the product cool down and
disconnect the spark plug connector before performing inspection, maintenance
and cleaning work!
1.Keep the product clean. Remove debris from it after each use and before storage.
2.Regular and proper cleaning will help ensure safe use and prolong the life of the product.
3.Inspect the product before each use for worn and damaged parts. Do not operate it if you
find broken and worn parts.
WARNING! Only perform repairs and maintenance work according to these
instructions! All further works must be performed by a qualified specialist!

GENERAL CLEANING

1.Clean the product with a damp cloth and mild soap. Use a brush for areas that are hard to
reach.
2.In particular clean the air vents (21) after every use with a cloth and brush.
3.Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive detergents or
disinfectants to clean this product as they might be harmful to its surfaces.
4.Check for any damage and wear. Repair damages in accordance with this instruction
manual or take it to an authorised service centre before using the product again.
Cutting device
WARNING! Wear safety gloves when working on the cutting device and close to
it! Use appropriate tools to remove debris, e.g. a brush or wooden stick! Never
use your bare hands!
The replacement of the cutting device should be done by a qualified specialist!
Rework or sharpening blades is not recommended unless it is done by a repair
service or a similarly qualified specialist!
1.Keep the cutting device (1) clean and free of debris. Remove trimmings
.
2.Apply a small amount of suitable lubricant on the cutting device (1) to retain a good cutting
performance (Fig. 24).
26CC PETROL HEDGE TRIMMER TTL688HDC