Installation; Installing The Rear Rail - Craftsman 113.29931 Owner's Manual

Rail and fence system for craftsman 10" table saws: 113.299310; 113.299510; 113.299410; 315.228310; 315.228410; 315.228510;
Table of Contents

Advertisement

INSTALLING
THE REAR
RAIL
A'_
WARNING:
Front and rear rails must be
carefully aligned to reduce the risk of kickback,
which can cause serious injury.
From the carton, remove the rear rail and the
following hardware:
Right and left end caps for rear rail
2 screws (5/32-32 x 1/2 in.) for end caps
Note: The square head bolts, washers, and hex nuts
shown at the top of figure 3 should still be on the
table saw. If you mistakenly
removed them, put
them back on the table. Do not tighten.
Carefully slide the rail onto the square head bolts.
SQUAREHEAD
BOLT
HEXNUT
FLAT WASHER
Position rail so that the right hand edge extends
2-1/2 in. beyond the table extension.
Note: Instructions are given from the operator's
position in front of the saw.
Push the rail against table and tighten each hex
nut with a 12 mm wrench. If the rail jams or does
not slide easily over the bolts, re-align the table
extensions according to the instructions
in the table
saw owner's manual.
Note: Make sure there are no gaps between the rail
and edge of table or extensions.
Put the end caps on the rail ends. Insert the
screws and tighten with a phillips screwdriver.
SCREW
Fig. 4
4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

113.29951113.29941315.22831315.22841315.2285129993 ... Show all

Table of Contents

Save Article as PDF