Navigating Between Modes; Cycling Between Timekeeping Mode Digital Display Contents; Shifting Hands To Read The Digital Display; Charging - Casio EDIFICE ECB-S100D-2A Operation Manual

Navigating Between Modes

Each press of (C) cycles between watch
modes.
In any mode, hold down (C) for at least one
●
second to return to the Timekeeping Mode.
Timekeeping Mode
C C
Alarm Mode World Time Mode
C
Timer Mode Stopwatch Mode
C
Connecting with a Phone
●
Hold down (C) for at least three seconds to
connect with a phone.
To disconnect, press any button.
●
Before connection After connection
C
Any button
Watch Operation Guide 5658
Cycling Between
Timekeeping Mode Digital
Display Contents
Each press of (A) in the Timekeeping Mode
toggles between the display information as
shown below.
Day of the week, date
Shifting Hands to Read the
Digital Display
Hand shift moves the hands out of the way for
easy viewing of display information.
1.
While holding down (B), press (C).
This will shift the analog hands to allow
●
easy viewing of display information.
C
2.
To return the hands to their normal
timekeeping positions, hold down (B) as
you press (C) again, or press (C) to
change to another mode.
Note
If you leave the watch with its hands
●
shifted and do not perform any
operation for about one hour, the
hands will resume normal timekeeping
automatically.
Seconds
Seconds
Hours, minutes

Charging

This watch runs on power supplied from a
rechargeable (secondary) battery that is
charged by a solar panel. The solar panel is
integrated into the face of the watch, and
power is generated whenever the face is
exposed to light.
Charging the Watch
●
When you are not wearing the watch, put it in
a location where it is exposed to bright light.
While you are wearing the watch, make sure
that its face (solar panel) is not blocked from
light by the sleeve of your clothing. Power
generation efficiency is reduced even when
the face of the watch is blocked only partially.
YES NO
Important!
Depending on light intensity and local
●
conditions, the watch may become hot
to the touch when exposed to light for
charging. Take care to avoid burn
injury after charging. Also, avoid
charging the watch under high-
temperature conditions like the ones
described below.
On the dashboard of a vehicle
ー
parked in the sun
Near an incandescent light bulb or
ー
other source of heat
Under direct sunlight or in other hot
ー
areas for long periods
7