Dahua IPC-HF5541F-ZE-S3 Quick Start Manual page 9

Port Name
Video output
VIDEO OUT
port
HDMI HDMI port
24 VAC/12
Power port
VDC
Red light
Green light
Indicator
Light
Yellow light
G GND
TX
RS-232 port
RX
B
RS-485 port
A
NA IR light port
Alarm input
I1
port 1
Alarm input
I2
port 2
N1
C1
Alarm output
N2
port
C2
P/G
(adjacent to Power output
P)
Table 1-1 Structure information
Description
● Outputs analog video signal. It can connect to TV monitor
to check image.
● Previews image via the DVR which supports HDCVI when it
outputs HDCVI signal.
Connects to HDMI monitor to preview image.
Inputs 12 VDC or 24 VAC power supply. Be sure to supply
power as instructed in the Manual.
● When using 24 VAC power, please connect the power
input port to 2PIN converter first.
● Camera abnormity or damage could occur if power is not
supplied correctly.
● System boots up: Red light is solid on.
● System upgrades: Green light flashes.
● System resets: Green light is off.
● The Camera works normally: Green light is solid on.
● The Camera is recording: Green light flashes.
● The Camera detects wireless device: Yellow light is solid
on.
Ground end of RS-232 serial port.
Sending end of RS-232 serial port.
Receiving end of RS-232 serial port.
RS485_B port, control external PTZ, and more.
RS485_A port, control external PTZ, and more.
External IR light signal control port.
Receives the on-off signal from the external alarm source.
Receives the on-off signal from the external alarm source.
● Alarm output port, output alarm signal to alarm device.
● N1/N2: Normally open alarm output end.
● C1/C2: Alarm output public end.
N1 can only be used with C1 while N2 can only be used with
C2 when connecting alarm device.
Supplies 12 VDC 2 W power for external devices. P connects to
positive pole while G connects to negative pole.
2
Quick Start Guide