BALDR B0340ST2H2 - WIRELESS WEATHER STATION WITH BACKLIGHT MANUAL

POWER ON

1. Main Unit Installation
   
   Step 1: Remove the battery compartment cover and insert 2xAAA batteries.
   Step 2: Take the metal stand out of the compartment and install it on the back of the unit.
2. Sensor Installation
   
   Step 1: Select the channel you desired to use.
   
   Step 2: Load the 2xAA batteries in 3 minutes to ensure RF signal received in time.

NOTE:

If not powered on in 3 minutes from the main unit powered on.

Press and hold "" button for 3 seconds to search RF signal again.

MAIN UNIT SETUP

1. Current time
2. Comfort level indicator
3. Indoor temperature and humidity
4. Ambient change indicator
5. Outdoor temperature and humidity
6. Window indicator

LCD will full display for 3 seconds.

Press "" button to select the channel on main unit you desire to use (Default in CH1)
Select the same channel number for both the sensor and the main unit in order to synchronize.

RF Signal Searching

The receiving antenna signal is flashing.

RF Signal Received

The receiving antenna signal will stop flashing.

Manual Setup

Press and hold "SET/C/F" button to enter into setup (3 seconds).
Press and release "SET/C/F" button to skip setting or go to next setting option (1 second).

1. Hour
2. Minute
3. 12/24 hours select
4. OFF/ON 24 hour or (Memory all the time)mode
5. Exit

Press "CH/" button to increase the values.

Press "MEM/" button to decrease the values.

*Tips: press and hold "CH/" or "MEM/ " button will quickly change the value by 8 steps.

This Qucik Start is to help you quickly set up the product. For detailed settings, please refer to the user manual, or scan the QR code below for relevant product information and operation video link. Thank you.