Using A Gps Unit - Nikon D2Hs User Manual

Using a GPS Unit

Garmin and Magellan GPS units that conform to version 2.01 of the National
Marine Electronics Association NMEA0183 protocol can be connected to
the camera's ten-pin remote terminal using an MC-35 GPS adapter cord
(available separately;
position to be recorded when photographs are taken. Operation has been
confi rmed with the following devices:
• Garmin eTrex series
• Magellan SporTrak series
These devices connect to the MC-35 using the cable provided by the manu-
facturer of the GPS device. See the MC-35 instruction manual for details.
Before turning the camera on, set the GPS device to NMEA mode.
When the camera establishes communication
with a GPS device, a
the top control panel. The exposure meters will
not turn off while this icon is displayed. Photo
information for pictures taken while the
displayed will include an additional page (
tude, longitude, altitude, and Coordinated Universal Time (UTC). If no data
are received from the GPS unit for two seconds, the
display and the camera will stop recording GPS information.
Coordinated Universal Time (UTC)
UTC data is provided by the GPS device and is independent of the camera clock.
GPS Data
GPS data are only recorded when the
played. Confi rm that the
top control panel before shooting. A fl ashing
indicates that the GPS device is searching for a signal;
pictures taken while the
clude GPS data.
239), allowing information on the camera's current
icon will be displayed in
icon is dis-
icon is displayed in the
icon is fl ashing will not in-
Recording GPS Data
icon is
130) recording the current lati-
icon will clear from the
icon
125