Swegon ESENSA Series Manual page 11

2.1.5 Product setup
Product setup is enabled in advanced settings with param-
eter "Enable Product Setup" (see the description of this
parameter in the list of advanced setting parameters).
When the Product Setup is enabled, it will be accessible
through the menu Settings/Product Settings, with access
code 5030.
Internal coils, so inside the unit, have to be declared in the
product settings.
Other parameters inside the product setup should be
changed only by trained person.
The options are provided separately from the unit with a
dedicated installation manual. Please refer to the installation
manual for the wiring diagrams.
Preheat
Indicates the presence of preheater inside the unit. See defi-
nition of Electrical preheating coil in Advanced setup. In case
of presence, select "KWin".
Setting Range Factory
Preheat None, KWin, BAin None
Postheat
Indicates the presence of postheater inside the unit. See defi-
nition of Electrical postheating coil and Water postheating
coil in Advanced setup. In case of Electrical postheating coil
presence, select "KWout". In case of Water postheating coil
presence, select "NV".
Setting Range Factory
Postheat None, KWout, NV None
2 0 www.swegon.com
GB.ESENSA.MC.2300818
We reserve the right to alter specifications.
3. REC type table
In the control board the "REC type" is used to define the type unit. When replacing the control board, the REC type
needs to be configured in the product setup menu. The product setup menu is used to enable specific features or to
modify factory settings. This must be done by an accredited technician. A code and special training is mandatory to
access this menu group. The table below is valid for controllers generation TAC.
ESENSA PX TOP
05 889002
09 889004
12 889008
13 889010
We reserve the right to alter specifications.
GB.ESENSA.MC.230818
ESENSA RX TOP
04 889100
05 889102
12 889156
16 889160
www.swegon.com 2 1