Setting Up An External Strobe; About Electrical Sync Cords; Ttl Strobe Compatibility - Ikelite 200DLM/A Instruction Manual

Underwater ttl housing for olympus om-d e-m5 mark ii mirrorless micro four-thirds cameras

Hide thumbs Also See for 200DLM/A:

Table of Contents

The port must be fully seated onto the housing for waterproof

operation. There should only be a very thin, even gap of

approximately 0.15" (4mm) between the bottom of the port and

the front of the housing.

Setting Up An External Strobe

We recommend attaching an external strobe for the optimal color and

clarity in a wide variety of photographic situations, including daylight

photography.

This housing provides a direct electrical connection to the camera's

external flash hotshoe via a flash hotshoe. An external strobe may be

triggered via electrical sync cord.

Connecting a strobe via electrical sync cord provides faster strobe

recycle times as compared to a fiber optic connection, and prolongs

camera battery life.

To connect two strobes to the camera, you must use a dual

sync cord.

A second slave strobe may be triggered optically off of a

primary strobe connected by sync cord.

When compatible Ikelite DS strobe(s) are attached by electrical sync

cord, the TTL circuitry built into the housing allows the camera to

communicate directly with the attached strobe(s). The camera triggers

the strobe(s) and adjusts the strobe(s) power automatically for perfect

exposure.

The following strobes are TTL compatible with this housing:

•

Ikelite DS50 above serial # 70000

Table of Contents

6950.52