DeWalt DCS727N-XJ Original Instructions Manual page 56

EnGLIsh

WARNING: Never use solvents or other harsh chemicals for cleaning
the non-metallic parts of the tool. These chemicals may weaken the
materials used in these parts. Use a cloth dampened only with water
and mild soap. Never let any liquid get inside the tool; never immerse
any part of the tool into a liquid.
Before use, carefully check the upper guard, lower guard and dust duct
to determine that they will operate properly. Ensure that chips, dust or
workpiece particles do not block of one of the functions.
In case of workpiece fragments jammed between the saw blade and
guards, remove the battery pack from the machine and follow the
instructions given in Changing or Installing a New Saw Blade. Remove
the jammed parts and reassemble the saw blade.
Periodically clean all dust and wood chips from around AND UNDER the
base and the rotary table.
Worklight Cleaning
• Carefully clean sawdust and debris from worklight lens with a cotton
swab. Dust build-up can block the worklight and prevent it from
accurately indicating the line of cut.
• DO NOT use solvents of any kind; they may damage the lens.
• With blade removed from saw, clean pitch and build-up from blade.
Dust Duct Cleaning
With the saw unplugged and the saw head raised fully, low pressure air or a
large diameter dowel rod can be used to clear the dust out of the dust duct.
Optional Accessories

WARNING: Since accessories, other than those offered by D
have not been tested with this product, use of such accessories with
this tool could be hazardous. To reduce the risk of injury, only D
recommended accessories should be used with this product.
Consult your dealer for further information on the appropriate accessories.
Clamp: DW7090-XJ (Fig. C)
The clamp 39 is used for firmly clamping workpiece to the saw table.
Quick Release Clamps: DWS5026-XJ
Dust Bag: DW7053-QZ (Fig. D)
Equipped with a zipper for easy emptying, the dust bag
majority of the sawdust produced.
Leg Stands: DE7023-XJ, DE7033-XJ (Fig. E)
The leg stand is used to extend the table width of the saw.
41
Clamp Brackets: DE7025-XJ (Fig. F)
The clamp brackets are used for mounting the saw to a stand.
42
sAW BLADEs: ALWAYS USE 250 mm SAW BLADES WITH 30 mm ARBOUR
HOLES. SPEED RATING MUST BE AT LEAST 4300 RPM. Never use a smaller
diameter blade. It will not be guarded properly. Use crosscut blades only!
Do not use blades designed for ripping, combination blades or blades with
hook angles in excess of 5°.
BLADE DEsCRIPTIOns
APPLICATION
Construction Saw Blades (thin kerf with anti-stick rim)
General Purpose
Fine Crosscuts
Woodworking Saw Blades (provide smooth, clean cuts)
Fine crosscuts
Non-ferrous metals
54
WALT,
e
WALT
e
40 will capture the
DIAMETER TEETH
250 mm 40
250 mm 60
250 mm 80
250 mm 96
Protecting the Environment
Separate collection. Products and batteries marked with this
symbol must not be disposed of with normal household waste.
Products and batteries contain materials that can be recovered or
recycled reducing the demand for raw materials. Please recycle
electrical products and batteries according to local provisions. Further
information is available at www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails to produce
sufficient power on jobs which were easily done before. At the end of its
technical life, discard it with due care for our environment:
• Run the battery pack down completely, then remove it from the tool.
• Li-Ion cells are recyclable. Take them to your dealer or a local recycling
station. The collected battery packs will be recycled or disposed of
properly.