Advertisement
Available languages
Available languages
EnGLIsh
battery terminals are protected and well insulated from materials that
could contact them and cause a short circuit.
NOTE: Lithium-ion batteries should not be put in checked baggage.
D
WALT batteries comply with all applicable shipping regulations
e
as prescribed by industry and legal standards which include UN
Recommendations on the Transport of Dangerous Goods; International Air
Transport Association (IATA) Dangerous Goods Regulations, International
Maritime Dangerous Goods (IMDG) Regulations, and the European
Agreement Concerning The International Carriage of Dangerous Goods by
Road (ADR). Lithium-ion cells and batteries have been tested to section 38.3
of the UN Recommendations on the Transport of Dangerous Goods Manual
of Tests and Criteria.
In most instances, shipping a D
from being classified as a fully regulated Class 9 Hazardous Material. In
general, only shipments containing a lithium-ion battery with an energy
rating greater than 100 Watt Hours (Wh) will require being shipped
as fully regulated Class 9. All lithium-ion batteries have the Watt Hour
rating marked on the pack. Furthermore, due to regulation complexities,
D
WALT does not recommend air shipping lithium-ion battery packs alone
e
regardless of Watt Hour rating. Shipments of tools with batteries (combo
kits) can be air shipped as excepted if the Watt Hour rating of the battery
pack is no greater than 100 Whr.
Regardless of whether a shipment is considered excepted or fully regulated,
it is the shipper's responsibility to consult the latest regulations for
packaging, labeling/marking and documentation requirements.
The information provided in this section of the manual is provided in good
faith and believed to be accurate at the time the document was created.
However, no warranty, expressed or implied, is given. It is the buyer's
responsibility to ensure that its activities comply with the applicable
regulations.
Transporting the FLEXVOLT
battery has two modes: Use and Transport.
The D
WALT FLEXVOLT
TM
e
Use Mode: When the FLEXVOLT
18V product, it will operate as an 18V battery. When the FLEXVOLT
is in a 54V or a 108V (two 54V batteries) product, it will operate as a 54V
battery.
Transport Mode: When the cap is attached
to the FLEXVOLT
battery, the battery is in
TM
Transport mode. Keep the cap for shipping.
When in Transport mode, strings of cells
are electrically disconnected within the pack resulting in 3 batteries with a
lower Watt hour (Wh) rating as compared to 1 battery with a higher Watt
hour rating. This increased quantity of 3 batteries with the lower Watt hour
rating can exempt the pack from certain shipping regulations that are
imposed upon the higher Watt hour batteries.
For example, the Transport Wh rating
might indicate 3 x 36 Wh, meaning 3
batteries of 36 Wh each. The Use Wh
rating might indicate 108 Wh (1 battery
implied).
Storage Recommendations
1. The best storage place is one that is cool and dry away from direct
sunlight and excess heat or cold. For optimum battery performance and
life, store battery packs at room temperature when not in use.
2. For long storage, it is recommended to store a fully charged battery
pack in a cool, dry place out of the charger for optimal results.
nOTE: Battery packs should not be stored completely depleted of charge.
The battery pack will need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels on the charger
and the battery pack may show the following pictographs:
46
WALT battery pack will be excepted
e
Battery
TM
TM
battery stands alone or is in a D
Example of Use and Transport Label Marking
Read instruction manual before use.
See Technical Data for charging time.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for the environment.
Charge D
chargers. Charging battery packs other than the designated
D
WALT batteries with a D
e
or lead to other dangerous situations.
Do not incinerate the battery pack.
WALT
e
USE (without transport cap). Example: Wh rating indicates 108
battery
TM
Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example: Wh rating
indicates 3 x 36 Wh (3 batteries of 36 Wh).
Battery Type
The DCS727 operates on a 54 volt battery pack.
These battery packs may be used: DCB546, DCB547, DCB547G, DCB548,
DCB549,. Refer to Technical Data for more information.
Package Contents
The package contains:
1 Assembled mitre saw
1 Blade wrench (assembled on the saw)
1 Saw blade (assembled on the saw)
1 Material clamp
2 Base extensions
2 Screws
2 Washers
1 Li-Ion battery pack (C1, D1, L1, M1, P1, S1, T1, X1, Y1 models)
2 Li-Ion battery packs (C2, D2, L2, M2, P2, S2, T2, X2, Y2 models)
3 Li-Ion battery packs (C3, D3, L3, M3, P3, S3, T3, X3, Y3 models)
1 Instruction manual
nOTE: Battery packs, chargers and kitboxes are not included with N models.
Battery packs and chargers are not included with NT models.
•
Check for damage to the tool, parts or accessories which may have
occurred during transport.
•
Take the time to thoroughly read and understand this manual prior
to operation.
WALT battery packs only with designated D
e
WALT charger may make them burst
e
WALT
e
Advertisement
