Download Print this page

Omron E3X-NA11 Instruction Manual page 16

User-friendly fiber-optic amplifier
Hide thumbs Also See for E3X-NA11:

Advertisement

E3X-NA
Mounting End Plate (PFP-M)
I
Depending on how it is mounted, an Amplifier Unit may move
during operation. In this case, use an End Plate.
Before mounting an End Plate, remove the clip from the master
Amplifier Unit using a nipper or similar tool.
Clip
The clip can also be removed using the following mechanism,
which is incorporated in the construction of the section under-
neath the clip.
1.
Insert the clip that is to be removed into the slit underneath
the clip on another Amplifier Unit.
2. Remove the clip by rotating the Amplifier Unit.
Rotate
Pull Strengths for Connectors (Including Cables)
E3X-CN11: 30 N max.
E3X-CN12: 12 N max.
16
Reflector
I
Use of E39-R3 Reflector
Use detergent, etc., to remove any dust or oil from the surfaces
where tape is applied. Adhesive tape will not be attached properly
if oil or dust remains on the surface.
The E39-R3 cannot be used in places where it is exposed to oil or
chemicals.
@
E39-F32
Protective Spiral Tubes
Insert a fiber to the Protective Spiral Tube from the head connec-
tor side (screwed) of the tube.
Protective Spiral
Tube
Push the fiber into the Protective Spiral Tube. The tube should be
straight so that the fiber is not twisted when inserted. Then turn
the end cap of the spiral tube.
Protective Spiral
Tube
Secure the Protective Spiral Tube on a suitable place with the
attached nut.
Mounting panel
Protective Spiral
Tube
Use the attached saddle to secure the end cap of the Protective
Spiral Tube. To secure the Protective Spiral Tube at a position
other than the end cap, apply tape to the tube so that the portion
becomes thicker in diameter.
Saddle
Tube
End cap
E39-F10 Fiber Connector
I
Mount the Fiber Connector as shown in the following illustrations.
Splice
Fiber Unit
Retention unit
Retention unit
Fiber Unit
The Fiber Units should be as close as possible when they are
connected.
Sensing distance will be reduced by approximately 25% when
fibers are connected.
Only 2.2-mm-dia. fibers can be connected.
E3X-NA
Fiber Unit
Fiber Unit
Hexagon clamping nut
Fiber Unit
Toothed washer
Fiber Unit
Fiber Unit

Advertisement

loading