Table of Contents
Advertisement
Getting Started
Connect any required peripherals to the appropriate port(s) of the MedView before
connecting to AC power.
Powering On the MedView:
Connect the MedView to AC power. This will automatically power on the codec,
camera and all electronics of the system which takes approximately 2 minutes.
During the power up phase the camera will go through an initialization routine
where it will move to the left/right and will stop at the last location it was used.
When the system has fully powered the camera will move to a pre-defined
privacy location. An image may or may not be displayed on screen depending
upon how the system has been set up and whether the infotainment switcher is
being used.
If it is necessary to confirm the system has been fully powered there are two
LED's behind the front grill which will be illuminated, as shown in Figure 23.
MedView Standby Mode
The system has been pre-configured to go into standby mode after a call is dropped, and
the camera will also move to the privacy position. The standby delay value can be
changed using the web interface of the codec (see Error! Reference source not found.
under MedView Administration).
Waking Up the MedView
The factory preset default condition of the
MedView is that it is always awake. An image will
only be displayed on the screen when a call is
made/received.
When a call is active the "On-Air" indicator will
illuminate
Copyright 2021 Iron Bow Technologies
Figure 23 – Internal LED Indicators
Figure 24 – "On-Air" Indicator
24
Advertisement
Table of Contents
