Kenwood CK 405 Operating Instructions Manual page 29

ANTI-TILT BRACKET
Important!
To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear
to fix it securely to the wall.
To fit the anti-tilt bracket:
1 . After you have located where the cooker is to be positioned, mark on the wall the place
where the two screws of the anti-tilt bracket have to be fitted.

Please follow the indications given in fig. 9.8.
2 . Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied .

Important!
Before drilling the holes, check that you will not damage any pipes or electrical


wires.
3 . Loosely attach the anti-tilt bracket with the two screws supplied .
4 . Move the cooker to the wall and adjust the height of the anti-tilt bracket so that it can
engage in the slot on the cooker's back, as shown in fig. 9.8.
5 . Tighten the screws attaching the anti-tilt bracket .
6 . Push the cooker against the wall so that the anti-tilt bracket is fully inserted in the slot
on the cooker's back .

Attention!

When sliding the cooker into place pay special attention not to trap the power
supply cable in the stability bracket.

Pay special attention to the gas connection hose.
Fig . 9 .8
29