Table of Contents
Advertisement
You see a confirmation message.
6. Click OK.
Parent topic:
Configuring the Group IPsec/IP Filtering Policies
You can configure group policies for IPsec/IP traffic filtering using Web Config.
1. Access Web Config and select the Network Security tab.
2. Under IPsec/IP Filtering, select Basic.
3. Click a tab number for the policy number you want to configure.
4. Select the Enable this Group Policy checkbox.
5. Select the filtering options you want to use for this group policy.
6. Click Next.
You see a confirmation message.
7. Click OK.
8. If you want to configure additional group policies, click the next tab number and repeat the
configuration steps as necessary.
Parent topic:
IPsec/IP Filtering Policy Settings
Default Policy Settings
Setting
Access Control
IKE Version
Authentication Method
Pre-Shared Key
Configuring IPsec/IP Filtering
Configuring IPsec/IP Filtering
Options/Description
Permit Access to permit IP packets to pass through
Refuse Access to prevent IP packets from passing
through
IPsec to permit IPsec packets to pass through
Select the version of the Internet Key Exchange (IKE)
protocol that matches your network environment
Select an authentication method, or select Certificate if
you have imported a CA-signed certificate
If necessary, enter a pre-shared key between 1 and 127
characters long
339
Advertisement
Table of Contents
