Table of Contents
Advertisement
Setting
Confirm Pre-Shared Key
ID Type
ID
Encapsulation
Remote Gateway(Tunnel Mode)
Security Protocol
Algorithm Settings
Group Policy Settings
Setting
Access Control
Options/Description
Confirm the pre-shared key you entered
If you selected IKEv2 as the IKE Version setting, select
the ID type from the list.
If you selected IKEv2 as the IKE Version setting, enter
the necessary ID information
If you selected IPsec as the Access Control option,
select one of these encapsulation modes:
Transport Mode: if you are using the product on the
same LAN; IP packets of layer 4 or later are encrypted
Tunnel Mode: if you are using the product on an Internet-
capable network, such as IPsec-VPN; the header and
data of IP packets are encrypted
If you selected Tunnel Mode as the Encapsulation
option, enter a gateway address between 1 and 39
characters long
If you selected IPsec as the Access Control option,
select one of these security protocols:
ESP: to ensure the integrity of authentication and data,
and encrypt data
AH: to ensure the integrity of authentication and data; if
data encryption is prohibited, you can use IPsec
Select the encryption algorithm settings for the security
protocol you selected
Options/Description
Permit Access to permit IP packets to pass through
Refuse Access to prevent IP packets from passing
through
IPsec to permit IPsec packets to pass through
340
Advertisement
Table of Contents
