Table of Contents
Advertisement
Step 2: Installing the main body
After loosening the screws, remove the mounting plate from the unit.
NOTE: If the pipe comes out on the left, it is necessary to loosen the screws on the bottom mounting
plate. If the pipe comes out in other directions, it is not necessary.
Fix the mounting plate with a tapping screw onto the wall.
NOTE: It is recommended to x it on the wall according to the hanging hole indicated by the
arrow on the mounting plate. Mounting plate must be installed horizontally.
Hang the indoor unit on the mounting plate.
(The bottom of body can touch the oor or remain
suspended, but the body must be installed
vertically.)
NOTE: After installation, the unit shall be kept
horizontal without tilting.
Page 22
Remove the mounting plate
Loosen the screw
Loosen the screws(Only for left outlet pipe)
Mounting plate
Tapping
screw
Washer
＜6mm
Advertisement
Table of Contents
